Toshiba e-STUDIO353 - Page 376

e-STUDIO350/352/353/450/452/453 © 2003 - 2008 TOSHIBA TEC CORPORATION All rights reserved
ADJUSTMENT
3 - 88
(4) Move the returning roller shaft to its lower limit (the slack of a belt is lightly taken); then, tighten
the screw on the tension arm plate.
Fig. 3-124
(5) Check to make sure that the returning roller shaft moves smoothly.
Fig. 3-125
Screw
Tension arm
plate
Returning
roller shaft
Returning
roller shaft