e-STUDIO350/352/353/450/452/453 © 2003 - 2008 TOSHIBA TEC CORPORATION All rights reserved
ADJUSTMENT
3 - 110
(9) Enter the value “3” in the setting mode (08-202).
(5) Connect the connector of the counter socket
to the harness connector of the equipment
side.
(6) Install the counter socket to the machine
frame with two M3 screws.
(7) Reattach the cover.
Fig. 3-151
(8) Insert the key copy counter with its arrow
mark pointing the rear side of the equipment.
Fig. 3-152
Screw
Counter socket
Harness connector
Key copy counter
To Next Page
Loading...
