© 2003 - 2008 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO350/352/353/450/452/453
PREVENTIVE MAINTENANCE (PM)
4 - 27
4
*s3.Stapler carrier shaft
Apply an adequate amount of white grease (Molykote EM-30L) to the entire stapler carrier shaft.
Fig. 4-26
*s4.Rack gear, pinion gear (Aligning plate)
*s5.Finishing tray shaft
1) Take off the metal shield plate.
* If the hole punch unit is installed, take it off beforehand.
2) Apply oil as follows through the opening which shows up when the metal shield plate has been
removed.
Apply an adequate amount of white grease (Molykote EM-30L) to the gear teeth of the rack and pin-
ion gears which drive the aligning plate, and the entire finishing tray shaft.
Fig. 4-27
Stapler carrier shaft
Finishing tray shaft
Rack gear
Pinion gear
06/01
To Next Page
Loading...
