e-STUDIO350/352/353/450/452/453 © 2003 - 2008 TOSHIBA TEC CORPORATION All rights reserved
FIRMWARE UPDATING
6 - 14
(8) Press the [START] button.
Updating starts and the processing status is displayed on the LCD screen.
(9) “Update Completed!!” is displayed at the bottom of the LCD screen after the updating is com-
pleted properly.
“Update Failed.” is displayed at the bottom of the LCD screen when the updating is not com-
pleted properly. Turn OFF the power, and then check the following items. After confirming and
clearing the problems, restart updating from the beginning.
• Is the download jig connected properly?
• Is the updating data written to the download jig properly?
• Do the download jig and the equipment operate properly?
To Next Page
Loading...
