9 - 14
9
e-STUDIO350/352/353/450/452/453
PAPER FEEDING SYSTEM
© 2003 - 2008 TOSHIBA TEC CORPORATION All rights reserved
Fig. 9-417
Fig. 9-419
Fig. 9-418
Fig. 9-420
Sensor arm
Bypass paper
sensor
Screw
Bypass feed upper cover
Screw
Screw
Bypass drive unit
(A-5) Bypass paper sensor
(1)
Take off the bypass unit ( Chapter 9.4 (A-1)).
(2) Take off the bypass feed upper cover
( Chapter 9.4 (A-4)).
(3)
Take off the upper plate ( Chapter 9.4 (A-4)).
(4) Take off the spring and sensor arm.
(A-6) Bypass pickup roller
(1)
Take off the bypass unit ( Chapter 9.4 (A-1)).
(2) Remove 1 screw and take off the bypass
feed upper cover .
(3) Remove 4 screws and take off the bypass
drive unit.
Spring
(5) Disconnect the connector from the sensor
and release the latch to take off the bypass
paper sensor.
To Next Page
Loading...
