14 - 18
14
e-STUDIO350/352/353/450/452/453
AUTOMATIC DUPLEXING UNIT
© 2003 - 2008 TOSHIBA TEC CORPORATION All rights reserved
(4) Remove the clip on the rear side.
(3) Remove the clip, pulley, pin and belt on the
front side.
(5) Remove 2 bushings and take off the middle
transport roller.
Fig. 14-530
Fig. 14-531
Fig. 14-532
Pin
Clip
Pulley
Belt
Clip
Bushing
Middle transport roller
Bushing
Fig. 14-529
[N] Middle transport roller
(1) Take off the ADU, ADU inside rear cover,
ADU opening / closing switch, paper guide,
and ADU cover ( Chapter 14.5 [A] to 14.5
[E]).
(2) Take off the ADU board.
ADU board
To Next Page
Loading...
