1.THE HIGH SECURITY MODE
Precautions on Using the High Security Mode 7
1 THE HIGH SECURITY MODE
Confirmation of the mode
When this equipment is operated under the high security mode, is displayed on the touch panel of the
equipment.
The HDD inside the equipment which is operated under the high security mode is encrypted. Moreover,
the Data Overwrite Option (GP-1070) is installed in such equipment.
To confirm that each function is operating, check the display at the top right of the [Counter] screen on
the touch panel of the equipment.
When the Data Overwrite Enabler is installed, the hard disk space temporarily used during the job
process will be used for another job after the data are overwritten when the user is logging out.
The HDD is encrypted.
The icon is displayed.
The HDD has been encrypted if this equipment is operated
under the high security mode.
The Data Overwrite Enabler is
operating properly.
The icon showing that the Data Overwrite Enabler is
correctly operating is displayed.
The version of the system which is running is displayed.
The system version to be displayed differs depending on the
equipment which is used.
e-STUDIO2550C Series: SYS V4.0
e-STUDIO5055C Series: SYS V4.0
e-STUDIO6570C Series: SYS V3.0 *
e-STUDIO507 Series: SYS V3.0 *
e-STUDIO857 Series: SYS V3.0 *
e-STUIDO407CS Series: SYS V2.0
e-STUDIO527S Series: SYS V2.0
e-STUDIO307LP: SYS V2.0
* ISO/IEC15408 certification accession version
To Next Page
Loading...
Need help?
General
