3 THE INITIAL VALUES
16 Precautions on the Initial Values
Precautions on the Initial Values
To securely operate the equipment, the initial and selectable values in the equipment under the high security
mode may differ from those under the normal security mode. This manual only explains about the initial
values and setting items which are different from those under the normal security mode.
To operate equipment complying with IEEE Std 2600.1
TM
-2009, be sure to change the initial values for the
high security mode listed in this chapter following the instructions described in the remarks column at the start
of use and keep them unchanged.
For the initial and setting values in the normal security mode, refer to the TopAccess Guide and MFP
Management Guide.
To reset all settings by performing “Initialization” of this equipment, back up the setting of this
equipment and customers’ data before initializing. For details, refer to the TopAccess Guide and MFP
Management Guide.
Logging in
The [User Management] and [Administration] tabs in TopAccess are displayed by logging in as a user with
the administrator privilege. Open TopAccess, click “Login” on the top right, and then enter the user name
and password to log in.
Be sure to log in the [ADMIN] tab in the [USER FUNCTIONS] mode of the equipment as a user with the
Administrator privilege.
Initial value list
[Administration] Tab
[Setup] Menu
[General] Sub Menu
* The value can be changed in the [ADMIN] tab in the [User Function] mode in the touch panel of the equipment.
Item
Initial value for the high
security mode
Remarks
Functions
Save as FTP Disable
Network iFax Disable
Network Fax Disable
Web Services Scan Disable
Twain Scanning Enable The initial value is the same as that of in the
Normal Security Mode; however, be sure to
set to OFF.
Restriction on Address Book Operation by Administrator
Can be operated by Administrator only
Energy Save
Auto Clear * 45 Seconds The initial value is the same as in the Normal
Security Mode; however, OFF cannot be
selected.