Toshiba e-STUDIO400AC - When Printed Sheets Overflow from the Exit Tray

When Printed Sheets Overflow from the Exit Tray 47
TROUBLESHOOTING FOR THE HARDWARE
0.When Printed Sheets Overflow from the Exit Tray
When thin, small size paper (B5/ST or smaller) is used, the end of the sheets may get stuck in the exit tray walls. Under
such condition, some printed sheets may be pushed out of the exit tray.
In the case above, installing the paper exit stopper at the designated location of the exit tray will increase the amount
of recommended plain paper that can be loaded on to the exit tray to about 150 sheets.
When printing a large number of large size sheets such as A4/LG and LT, place the paper exit stopper back in its
original location.
Removing the paper exit stopper from its original location
1
Unfold the paper exit stopper located on the left of the exit tray and remove it from its groove
while pushing the fulcrum inward.
Installing the paper exit stopper in the designated location for improving paper exit
1
Turn the tip of the paper exit stopper to the right and insert the paper exit stopper fulcrum into
the groove on the exit tray.
Placing the paper exit stopper back in its original location
1
Remove the paper exit stopper from the groove on the exit tray while pushing its fulcrum inward.
2
Install the paper exit stopper in the groove on the left of the exit tray.