EDITING FUNCTIONS
- 15 -
7
Select other copy modes as required, and
then press the [START] button on the
control panel.
When the originals are placed on the RADF, scanning
and copying start.
When they are placed on the original glass, follow steps 8
and 9.
8
Place the next original, and then press
[NEXT COPY] on the touch panel or the
[START] button on the control panel.
Scanning of the next original starts. Repeat this
procedure until the scanning of all the originals is finished.
9
When the scanning of all the originals is
finished, press [JOB FINISH] on the touch
panel.
Copying starts.
Sheet Insertion
You can insert a special type of paper such as colored paper at
the desired page. This function is called “sheet insertion”. You
can insert up to 2 types of sheets for a total of 50 pages. The
sheet insertion mode has the following 2 types:
COPIED: Inserts a copied sheet, replacing the specified page.
BLANK: Inserts a blank sheet before the specified page.
1
Place sheets for sheet insertion.
Place them on the bypass tray or in a drawer previously
set for insertion sheets. The paper for the insertion sheets
must be placed in a different paper source than normal
paper.
Note
• When placing paper in a drawer for sheet insertion, be
sure to select “INSERT 1” or “INSERT 2” as a paper
type, and also set the paper size and thickness.
• When placing paper on the bypass tray, be sure to set
the paper size and thickness.
Basic Guide
• Place the paper for insertion sheets of the same size
as normal paper in the same direction.
2
Place the normal paper in the drawer(s).
3
Place the original(s).
When placing them on the original glass, they must be
placed from the first page.
4
Press [SHEET INSERTION] on the EDIT
menu.
REPORT
2003
1
2
3
4
4
3
REPORT
2003
2
To Next Page
Loading...
