Toshiba e-Studio477s - Setting the Weekly Timer; Setting the Energy Saver Modes

SETTING ITEMS (ADMIN)
- 164 -
2
1
3
4
5
6
7
2
Press the desired date format button.
You will be returned to the CLOCK menu screen.
Setting the energy saver modes
You can set the following energy saver modes.
• Weekly timer
 P.164 "Setting the weekly timer"
Using the built-in weekly timer, you can have the equipment
automatically turned ON and OFF at specified times. For
instance, you can set the timer for the starting time and
closing time of your office so that the copier will
automatically turn itself ON and OFF at those specified
times.
Memo
• You can turn on the power by simply pressing the
[START] button on the control panel when the device is
in the Sleep mode by the weekly timer.
Note
• When the power switch is turned off, the weekly timer
does not work.
• Auto Power Save mode
 P.165 "Setting the Auto Power Save mode"
This function allows the equipment to automatically go into
the energy saver mode if it is left inactive for a certain
period of time.
• Auto Sleep mode
 P.165 "Setting the Auto Sleep mode"
This function puts the equipment into the Sleep mode if it is
left inactive for a certain period of time. In the Sleep mode,
power to the unused sections of this equipment is shut off
while this equipment is in the standby status.
Memo
• For the types of Energy Saver modes and procedures
for entering each mode.
Note
• Neither the [AUTO POWER SAVE] nor [AUTO SLEEP]
button is displayed in the European version. Contact
your service representative to change the default setting
for each button.
Setting the weekly timer
1
On the POWER SAVE screen, press
[WEEKLY TIMER].
The TIMER screen is displayed.
2
Check the settings on the display. If
changes are required, press [CHANGE].
If no changes are required, press [OK] and complete the
operation.
3
Make settings for the weekly timer.
1) Press the button of the desired day of the week.
2) Press [ON] to enter the time the device wakes up
from the Sleep mode.
Use the arrow buttons to switch the active box
between “Hour” and “Minute”.
3) Press [OFF] to enter the time to put the device into
the Sleep mode.
Use the arrow buttons to switch the active box
between “Hour” and “Minute”.
4) Press [OK] to save the settings.
Memo
• If you want to clear an entered time, press the
[CLEAR] button on the control panel.
• If you want to put the equipment into the Sleep
mode for an entire day, enter the same time in both
the [ON] and [OFF] boxes.
Example) When you enter “0:00” in both the [ON]
and [OFF] boxes for [SUN],
the equipment automatically goes into the Sleep
mode at the [OFF] time specified for [SAT]. The
Sleep mode is kept until the [ON] time specified for
[MON] comes.
• If you do not want to put the equipment into the
Sleep mode for an entire day, make settings for the
desired day of the week as follows:
[ON]: 0:00 / [OFF]: 24:00
The equipment does not go into the Sleep mode for
an entire day, which is activated by the weekly
timer function. However, the equipment
automatically goes into the Sleep mode according
to the time value set for [Auto Sleep mode], if it is
left inactive for a certain period of time.