Toshiba E-STUDIO6506AC - Page 187

e-STUDIO5506AC/6506AC/7506AC (Ver01) © 2016, 2017 TOSHIBA TEC CORPORATION All rights reserved
3-51
3. Printer-specific Adjustments
* This adjustment will have an effect only on full-color printing.
(3) Select [05 ADJUSTMENT MODE] and adjust the toner limit by setting a value smaller than the default for
[8070/8071/8090/8089].
Resolution
Halftone
[05]
code
Subcode
Recom
mended
value
Acceptable
value
range
Default
600dpi
Smooth 05-8071 0~8,11,12
Set a
value
smaller
than the
default.
0 to 255 128
Detail 05-8070 0~8,11,12
1200dpi
Smooth 05-8090 0~8,11,12
Set a
value
smaller
than the
default.
0 to 255 128
Detail 05-8089 0~8,11,12
* Set the value in increments of approximately 30, while checking the printouts until the optimum value is
obtained.
Subcode
Original
0
Plain paper 1
1
Thick
2
Recycled paper
3
Thick 1
4
Thick 2
5
Thick 3
6
Thick 4
7
Special 1
8
Special 2
11
Envelope
12
OHP

Caution after the adjustment
• The adjustment in procedure (1) may possibly provide insufficient photo contrast images. Therefore, carefully
perform the adjustment, while checking the printouts.
• The adjustment may possibly cause an increase in the amount of toner used, moiré, blurred text (blurring of
small and dark text), faint text (fine outlines of text shredded), diminished photo images or gradational images
(less accurate reproducibility of halftones), or in some consumption conditions, background fogging or a
decrease in the amount of developer material (carrier streaks). Therefore, carefully perform the adjustment,
while checking the printouts.
• The adjustment may possibly cause dark areas such as making shades on photo images look unnaturally faint.
Therefore, carefully perform the adjustment, while checking the printouts.
PCL6
PS3
XPS
Mac