e-STUDIO5506AC/6506AC/7506AC (Ver01) © 2016, 2017 TOSHIBA TEC CORPORATION All rights reserved
1 - 10
1. General Adjustments – Copying, Printing and e-Filing (Output from Box)
(b) Perform automatic calibration.
* Be sure to perform automatic calibration not only with the paper types adjusted in step (1) and (2),
but also all paper types. Refer to the following table for adjustment.
How to perform automatic calibration
Perform step (1) referring to "2.13 To Obtain a Good Color Balance on
Thick Paper". Perform step (2) and later if required.
Perform step (2) referring to "3.2 To Maintain a Steady Color Balance on
Thick Paper or Special Paper".
* After replacing any consumable, remember to reset the counter corresponding to it to "0." Otherwise, it
may cause a loss in MFP performance, including degradation in the image quality and a reduction in the
life of the consumables.
Caution after the adjustment
• The adjustment may possibly cause an increase in the amount of toner consumed, scattering of the toner,
diminished photo images or gradations (less accurate reproducibility of halftones), extremely dark images
(decreased resolving power), extremely light images (faint thin lines), and shorten the life of the consumables.
Therefore, carefully perform the adjustment, while checking the copy or print image.
• No effect of the adjustment may appear, depending on the installation environment of the MFP. Therefore,
carefully perform the adjustment, while checking the copy or print image.
Remarks
• The effect of the adjustment may vary, depending on the usage pattern of the consumables, such as the
developer material and drum, and the installation environment of the MFP.
• When replacing any consumable, refer to the relevant information in the Service Manual.
To Next Page
Loading...
