Toshiba E-STUDIO6506AC - Page 37

e-STUDIO5506AC/6506AC/7506AC (Ver01) © 2016, 2017 TOSHIBA TEC CORPORATION All rights reserved
1 - 21
1. General Adjustments – Copying, Printing and e-Filing (Output from Box)
(C). To stabilize the image quality on halftones in pictures (when interrupting jobs and
starting the Full Mode at every 250 pages)
Code to set
number of
pages
Setting
value *7
Starting conditions
Full IQC
08-2509
250
The control starts after every 250 pages.
Short IQC
08-2497
250
When a job is interrupted after every 250 pages.
Printing
interrupted
08-9199 250
*7. When the number of times in the Full Mode increases, more toner is consumed.
(D). To emphasize performance (for less use of the Short Mode)
Code to set
number of
pages
Setting
value *8
Starting conditions
Full IQC 08-2509 2000 The control starts after every 2000 pages.
Short IQC
08-2497 500
The control starts only when a job is interrupted after 500
pages have been output.
Printing
interrupted
08-9199 500
*8. When the Full Mode and the Short Mode are set simultaneously, the former has a priority.
If you never want to start the Short Mode, set “1” (Disabled) to code 08-2495. (0: Enabled)
Notes:
・Set the value in consideration of users’ requests and the total number of pages output in a day. To maintain
the optimal image quality, it is recommended to start the Short Mode at least two or three times a day.
・Do not set the number of output pages smaller than 50 for codes 08-2509 and 08-9199 because this affects
the life of consumables such as a cleaning blade.
・Changing this setting improves the stability of the image quality. However, a long application of this
change affects the life of consumables. It is recommended to make only a minimal change and then
return to the default value immediately.