Configuring Analog Outputs
Introduction
The G7 will output a variety of information, for either monitoring or feedback purposes, through either
the AM or FM terminal or through one of two analog outputs available on an option card. The table
below shows the drive parameters that can be monitored through the analog output terminals.
Output Measured in
Output Frequency Hz
Frequency Reference Hz
Output Current % of maximum Amps
DC Bus Voltage % of maximum Volts
Output Voltage % of maximum Volts
Post Compensation Frequency Hz
Speed Feedback (real time) -
Speed Feedback (1 sec filter) -
Torque % Torque
Torque Command % Torque
Internal Torque Base -
Torque Current % of maximum Amps
Excitation Current % of maximum Amps
PID Feedback Value -
Motor Overload Ratio %
ASD Overload Ratio %
PBR Overload Value %
PBR Load Ratio %
Input Power kW
Output Power kW
Peak Output Current % of maximum Amps
Peak DC Bus Voltage % of maximum Volts
PG Counter -
Position Pulse -
RR Input % of maximum input
VI/II Input % of maximum input
RX2 Input % of maximum input
FM Output % of maximum output
AM Output % of maximum output
Meter Adjust Value -
* For additional assistance, please contact Toshiba Adjustable Speed Drive Marketing Dept. at (800) 872-2192
23
efesotomasyon.com -Toshiba inverter,drive,servo,plc
To Next Page
Loading...
