H7 ASD Operation Manual Appendix C 201
EOI Remote Mounting w/o the ASD-MTG-KIT
Note: See Figure 31 for the dimensions and the item locations referenced in steps 1 through 5.
1. At the EOI mounting location, identify and mark the location of the 3.80” by 3.29” hole and the
7/32” screw holes.
2. Cut the 3.80” by 3.29” rectangular hole.
3. Drill the four 7/32” screw holes.
4. Attach and secure the EOI to the front side of the mounting location using the four 6-32 x 5/16” pan
head screws, the #6 split lock washers, and the #6 flat washers.
5. Connect the RJ-45 extension cable(s).
EOI Dimensions (mounting)
Figure 31. EOI Mounting Dimensions.
EOI Remote Mounting using the ASD-MTG-KIT
Note: See Figures 32 and 33 for the dimensions and the item locations referenced in steps 1
through 6.
1. At the EOI mounting location, identify and mark the locations of the 5.00” by 4.60” hole and the
four 11/32” screw holes.
2. Cut the 5.00” by 4.60” rectangular hole.
3. Drill the four 11/32” holes.
4. Attach and secure the Bezel plate to the front side of the mounting location using the four 10-32
hex nuts, #10 split lock washers, and the #10 flat washers.
5. Attach and secure the EOI to the front side of the Bezel plate using the four 6-32 x 5/16” pan head
screws, #6 split lock washers, and the #6 flat washers.
6. Connect the RJ-45 extension cable(s).
www . ElectricalPartManuals . com
To Next Page
Loading...
