Toshiba H7 - Command Source Selection; Frequency Reference Source Selection; Wizard Finish

H7 ASD Operation Manual 29
Command Source
This selection allows the user to establish the source
of the Run commands (e.g., F, R, Stop, etc.).
Settings:
Use Control Terminal Strip
Use LED Keypad Option
Use Common Serial (TTL)
Use RS232/485
Use Communication Card
Frequency Reference Source
This selection allows the user to establish the source
of the Frequency (speed) command.
Settings:
Use VI/II
Use RR
Use RX
Use Option Card RX2
Use LED Keypad Option
Use Binary/BCD Input
Use Common Serial (TTL)
Use RS232/485
Use Communication Card
Use Motorized Pot Simulation
Use Pulse Input Option
Wizard: Finish
This screen is the final screen of the Startup Wizard.
The basic parameters of the ASD have been set. Click
Finish to return to the Program mode. Additional
application-specific programming may be required.
www . ElectricalPartManuals . com