To Next PageTo Next PageWhy won't the compressor start on my Toshiba MMU-AP0244SH-E Air Conditioner?
If the compressor of your Toshiba Air Conditioner won't start, consider these possibilities: * It might be within the 3-minute delay period after a compressor shutdown. * The air conditioner might have thermo OFF. * It could be operating in fan mode or set on a timer. * The system might be undergoing initial communication.
Why won't the indoor fan stop on my Toshiba MMU-AP0244SH-E Air Conditioner?
If the indoor fan of your Toshiba Air Conditioner won't stop, it might be performing the elimination of residual heat as part of the air conditioner shutdown process after heating operation.
Why won't the indoor fan start on my Toshiba MMU-AP0244SH-E?
If the indoor fan of your Toshiba Air Conditioner won't start, it could be due to cold air discharge prevention control, which is a part of the heating process.
Why does the outdoor fan on my Toshiba Air Conditioner not start or change speed?
If the outdoor fan of your Toshiba Air Conditioner doesn't start or changes speed unexpectedly, it might be due to cooling operation under low outside temperature conditions or during a defrosting operation.
General| Brand | Toshiba |
|---|---|
| Model | MMU-AP0244SH-E |
| Category | Air Conditioner |
| Language | English |
Covers DANGER, WARNING, CAUTION, electrical safety, protective gear, work practices, and refrigerant handling.
Details safety measures for operation, maintenance, installation, and relocation.
Lists sound power levels and weights for various indoor unit models.
Provides the wiring diagram for the Compact 4-way cassette indoor unit.
Covers wiring diagrams for both compact YH and SH types of 1-way cassette units.
Lists components and part numbers for Compact 4-way, 1-way cassette, Concealed Duct, and Slim Duct indoor units.
Details components for Ceiling, Floor Standing Cabinet, Concealed, and Floor Standing units.
Illustrates the refrigerant cycle and functional parts within the indoor unit.
Details system operations, fan speed control, special recovery cycles, and standby modes.
Shows block diagrams for main/wireless remote and combined controller connections.
Covers optional connector specs, DN code settings, and P.C. board details.
Guides users on initial checks, tools, and troubleshooting steps for common issues.
Lists check codes for indoor, outdoor, and central control devices with fault descriptions.
Provides resistance vs. temperature data for indoor unit sensors (TA, TC1, TC2, TCJ).
Details procedures for replacing P.C. boards, EEPROM data reading, and writing.
Details the procedure for removing and attaching the air intake grille and other parts.
Explains how to detach and attach the air intake grille and electric parts cover.
Covers the removal and attachment of air filters and plate inlets for slim duct units.
Shows exploded views and lists parts for YH type indoor units.
Provides exploded views and parts lists for SH type indoor units.
Displays exploded diagrams and parts lists for compact 4-way cassette indoor units.
Details refrigerant concentration limits, room volume standards, and minimum floor area requirements.
