– 30 –
Confirming the indoor unit addresses and the position of an indoor unit using the remote
controller
Confirming the numbers and positions of indoor units
To know the indoor unit addresses though position of the indoor unit is
recognized
When the unit is individual (the indoor unit is paired with a wired remote controller one-to-
one), or it is a group-controlled one.
<RBC-AMT
>
(Execute it while the units are running.)
1 Push the button if the units stop.
2 Push the
UNIT LOUVER
button (left side of the button).
A unit numbers 1-1 is indicated on the LCD (it will disappear after a few seconds). The indicated number
shows the system address and indoor unit address of the unit.
When 2 or more indoor units are connected to the remote controller (group-controlled units), a number of
other connected units appears each time you push the
UNIT LOUVER
button (left side of the button).
NOTE: The LED on the P.C. board of the selected hot water module flashes. The hot water module for change
settings can be confirmed.
<RBC-ASCU11
>
There is no such function in the remote controller.
Starts
running
TEMP.
ON / OFF
UNIT
CODE No.
No.
SET
TIME
TIMER SET
TEST
FILTER
RESET
CL
FAN
SAVE
SWING/FIX
VENT
MODE
UNIT LOUVER
1
2
To Next Page
Loading...
