– 31 –
To find an indoor unit’s position from its address
When checking unit numbers controlled as a group
<RBC-AMT
>
(Execute it while the units are stopped.)
The indoor unit numbers in a group are indicated one after another. The fan and louvers of the indicated units
are activated.
1 Push and hold the and buttons at the same time for more than 4 seconds.
• ALL appears on UNIT No. on the LCD display.
• The fans and louvers of all the indoor units in the group are activated.
2 Push the
UNIT LOUVER
button (left side of the button). Each time you push the button, the indoor
unit numbers are indicated one after another.
• The first-indicated unit number is the address of the header unit.
• Only the fan and louvers of the indicated indoor unit are activated.
3 Push the button to finish the procedure.
All the indoor units in the group stop.
NOTE: The LED on the P.C. board of the selected hot water module flashes. The hot water module for change
settings can be confirmed.
<RBC-ASCU11
>
1 Push and hold the [menu + ] buttons at same time for more than 10 seconds.
e.g.) A unit number 1-1 is indicated on the LCD. The indicated number shows the system
address and indoor unit address of the unit.
2 When 2 or more indoor units are connected to the remote controller (group-controlled
units), a number of other connected units appears each time you push the [
or ]
buttons.
3 Push the [ON/OFF] button, return to the normal mode.
2
1
3
To Next Page
Loading...
