Toshiba MMW-UP0271LQ-E - Page 86

– 86 –
Sensor TC1 and
TWO (TC2)
1. Detachment
1) Carry out the detachment of item
3
(Electrical control
box).
2) Remove connectors which are connected from the
control P.C.board to the other parts and then remove
wiring from the clamp.
CN101 ... TWO (TC2) Black 2P
CN100 ... TC1 Brown 3P
2. Attachment
1) Carry out installation by following the detachment
procedure in reverse.
NOTE:
• Be careful in the insertion direction about attaching the
sensor, as shown below.
• Let TC1 and TWO (TC2) wiring pass through the right
side clamps.
Refer to item
3
(Electrical control box).
No. Part to be replaced Work procedure Remarks
13
Sensor
TCJ, TCJ2 (TF) and
TWI (TA)
1. Detachment
1) Carry out the detachment of item
1
(Front panel).
2) Remove connectors which are connected from the
control P.C.board to the other parts and then remove
wiring from the clamp.
CN102 .... TCJ Red 2P
CN103 .... TCJ2 (TF) Green 2P
CN104 .... TWI (TA) Yellow 2P
2. Attachment
1) Carry out installation by following the detachment
procedure in reverse.
NOTE:
• Be careful in the insertion direction about attaching the
sensor, as shown below.
• Let TCJ, TWI (TA) and TCJ2 (TF) wiring pass through
the letf side clamps.
Refer to item
3
(Electrical control box).
12
TCJ
Tube color:Red
TCJ2 (TF)
Tube color:Gray
For TWI (TA), TCJ and
TCJ2 (TF) Insertion
drection : ←
TWI (TA)
Tube color:Black
TCJ2 (TF)
Tube color:Gray
For TWI (TA), TCJ and
TCJ2 (TF) Insertion
drection : ←
TWI (TA)
Tube color:Black
TCJ
Tube color:Red
For TWO (TC2) and TC1
Insertion drection : →
For TWO (TC2) and TC1
Insertion drection : →
TC1
Tube color:Blue
TWO (TC2)
Tube color:Black