Toshiba MMY-MAP0724FT9UT - Page 12

–11–
3 Push the button to confirm the
direction of the selected louver.
Each time the button is pushed, the indication
changes as follows:
* When cooling or drying, (4) and (5) are not
displayed.
◆ Setting the swing pattern
1 Push and hold the FIX for at least 4
seconds while the operation is stopped.
blinks.
2 Push the button (left side of the button)
to select a unit.
The unit number changes each time the button is
pushed.
The fan of the selected unit runs, and the louver
swings.
3 Push the buttons to select a swing
type.
REQUIREMENT
Do not set “0000”.
(The louver may be damaged.)
4 Push the button.
5 Push the button to finish the setting.
▼ Standard swing
All four louvers swing simultaneously at the same
angle.
▼ Dual swing (Recommended for heating)
• Adjoining louvers alternately point horizontally and
downward to heat the room evenly.
• Air blown downward reaches the floor, and air blown
horizontally is spread to circulate heat.
Swing code Movement pattern
0001
Standard swing
(factory default)
0002 Dual swing
0003 Cyclic swing
SWING/FIX
(1) (2) (3) (4)
(7) (6) (5)
SWING/FIX
UNIT LOUVER
No
display
Unit No.
1-1
Unit No.
1-2
Unit No.
1-3
Unit No.
1-4
Swing code
Swing
Horizontal
Downward
Downward
Horizontal
Downward
Downward
Horizontal
Horizontal
▼ Cyclic swing (Recommended for cooling)
All four louvers swing at different times like waves.
◆ Setting the louver lock
1 Push and hold the button (right side of
the button) for at least 4 seconds while
running is stopped.
blinks.
• When no unit number is displayed, all units are
selected.
2 Push the button (left side of the button)
to select a unit.
The unit number changes each time the button is
pushed.
The fan of the selected unit runs, and the louver
swings.
3 Push the “TEMP. ” buttons to
display the number of the louver to fix its
direction.
The selected louver swings.
4 Push the buttons to select the
direction of the louver you do not want to
swing.
* If (4) or (5) is selected, condensation may occur
during cooling.
5 Push the button to confirm the setting.
When the setting is confirmed, the mark lights
up.
(To set the louver lock of another unit, repeat from
Step 2. To set another louver lock of the same unit,
repeat from Step 3.)
(3)
(2)
(1)
(1)
(4)
(2)
(3)
(2)
(3)
(4)
(1)
(4)
(3)
(2)
(1)
(4)
UNIT LOUVER
UNIT LOUVER
Unit No.
1-1
Unit No.
1-2
Unit No.
1-3
Unit No.
1-4
(1)
0001
(2)
0002
(3)
0003
(5)
0005
(4)
0004
03
01
0204
Refrigerant
pipe
Drain pipe
Electrical control box
21-EN 22-EN
+00EH99943901_00Ta.book Page 11 Thursday, May 23, 2013 7:17 PM