–15–
Cleaning Unit Grille and Frame
To clean the grille and the frame, wipe the outside with
a soft, dry cloth. If necessary, a mild liquid detergent
can be applied and wiped off with a dry cloth.
Cleaning The Louvers
1 Remove the discharge louver by holding it at
both ends and pulling downwards towards
the center.
2 Clean the louvers with water or mild
detergent.
3 Mount the discharge louver by inserting one
end and bending it outwards to allow the
other end to be inserted.
Install the louvers as side with marking faces upwards.
Preparing for long Shut Down Period
1 Clean the filters and reposition them in unit.
2 Operate the unit in fan mode for 3 or 4 hours
to dry all internal parts.
3 Turn the unit off and disconnect the main
power supply.
4 Before unit is turned on again, make sure the
circuit breaker has been turned on for at
least 12 hours.
Ceiling cassette type
Cleaning the air filter
If is displayed on the remote control, clean the air
filter.
1 Open the air intake by sliding the latches.
Let the grille drop while holding it.
2 Remove the air filter from grille.
3 Vacuum the filter and rinse it with water.
4 Dry the filter.
5 Wipe the inside of the air intake with water or
mild detergent and then dry it.
6 Reinstall the filter.
7 Close the grille and secure it to the frame by
the latches.
8 Push button to reset filter timer.
“FILTER ” disappears.
2)Insert in the louver sagging
down the center downward.
1) Insert
Hook
Air filter
Handle
Handle
Hook
Air intake
Latch
Air filter
Do not start the air conditioner while leaving the panel
and air filter removed.
Cleaning Unit Grille and Frame
To clean the grille and the frame, wipe the outside with
a soft, dry cloth. If necessary, a mild liquid detergent
can be applied and wiped off with a dry cloth.
Preparing for long Shut Down Period
1 Clean the filters and reposition them in unit.
2 Operate the unit in fan mode for 3 or 4 hours
to dry all internal parts.
3 Turn the unit off and disconnect the main
power supply.
4 Turn on the circuit breaker for at least 12
hours before unit is turned on again.
Compact 4-way cassette type
1 Open the air intake grille.
Slide the air intake grille buttons to detach the air
intake grille from the main ceiling panel. Lower the
grille slowly whilst holding.
2 Take out the air filter.
Push the extrusion of the air filter away from the
grille and remove.
3 Cleaning with water or vacuum cleaner
• If dirt is heavy, clean the air filter using tepid
water with a neutral detergent or just water.
• After cleaning with water, dry the air filter
sufficiently in a shaded place.
4 Mount the air filter.
5 Close the air intake grille.
Close the air intake grille, slide the button to locate
into the ceiling panel fixing securely.
6 Push the “FILTER RESET ” button.
display disappears.
Air filter
Strap to prevent
falling
29-EN 30-EN
+00EH99943901_00Ta.book Page 15 Thursday, May 23, 2013 7:17 PM
To Next Page
Loading...
