EN
–16–
◆ Cleaning of air discharge louver
The air discharge louver can be removed to clean if
necessary.
1 Remove the air discharge louver.
Holding both ends of the air discharge louver,
remove it by sagging the center downwards.
2 Clean the air discharge louver with water.
If dirt is heavy, clean the air discharge louver using
tepid water with neutral detergent or just water.
3 Mount the air discharge louver.
First push in the one side, and insert the opposite
side by sagging the center downwards.
Insert the louver in the correct direction.
Insert the louver with the printed mark facing upwards,
and the arrow on the louver pointing in the outward
direction.
Medium static ducted type
Air filter replacement
If is displayed on the remote control, replace the air
filter.
1 Push the button to stop the
operation, then turn off the circuit breaker.
2 Replace the new air filter. (locally procured)
1) Remove the cover plate.
Remove the cover plate with 2 screws.
(2) Insert in the louver
sagging down the
center downward.
(1) Insert
Cover plate fixing
screws
2) Pull out the filter rack, and set the air filter
(locally procured) in it.
3) Push the filter rack in fully and reattach the
cover plate. (Screws x 2)
3 Turn on the circuit breaker, then push the
button on the remote control to start
the operation.
4 After cleaning, push .
display disappears.
• Do not start the air conditioner while leaving air filter
removed.
• Push the filter reset button. ( indication will be turn
off.)
Filter rack
Air filter
(locally procured)
Air filter
(locally procured)
31-EN 32-EN
+00EH99943901_00Ta.book Page 16 Thursday, May 23, 2013 7:17 PM
To Next Page
Loading...
