13-2-6.Noise Filter P.C. Board (MCC-1608 A, B) Replacement
Procedure
<1. Preparation (model selection)>
All P.C. boards of this type leave the factory with default settings that are common to all applicable models. When
replacing a P.C. board assembly on site, follow the procedure described below.
<2. Replacement steps>
(1)Turn off the power to the outdoor unit.
(2)Remove the terminal block sub-assembly (
1).
Remove the screws (
2) on the power supply terminal block (4) and the screws (3) securing the terminal block
subassembly (
1).
• The screws will be reused during the installation of the service P.C. board, so keep them in a safe place.
Part code Description Applicable model P.C. board type code Product code
43T 6V 407 Noise filter P.C. board MMY-MAP0804HT5 P(JP)
MMY-MAP1004HT5 P(JP)
MMY-MAP1204HT5 P(JP)
MMY-MAP1404HT5 P(JP)
MMY-MAP1604HT5 P(JP)
MCC-1608-A, B ASM-PCB (N/F)
To Next Page
Loading...
