1
8
3
5
2
9
10
6 7
12
4
11
SET
TIME
TIMER SET
TEST
FILTER
RESET
TEMP.
CL
FAN
SAVE
SWING/FIX
VENT
MODE
ON / OFF
UNIT LOUVER
1, 3
2
11
button (Unit/Louver select button)
Selects a unit number (left) and louver number
(right).
UNIT button:
If two or more indoor units are controlled by one
remote controller, use this button to select a unit
to adjust its air blow direction.
LOUVER button: (4-way cassette type only)
Selects a louver to control when adjusting the
louver lock setting or wind direction setting
separately for each louver.
12
button
Adjusts the set temperature.
Select the desired set point by pushing TEMP.
or .
OPTION:
Remote controller sensor
Normally the temperature sensor of the indoor unit
senses the temperature. The return air temperature
around the remote controller can also be sensed. For
details, contact your dealer.
* Do not use the function when the air conditioner is
controlled in a group.
1
Push the button.
The operation lamp lights up.
2
Push the “MODE ” button to select a
operation mode.
Each time you push the button, the operation
mode and its icon change in the following order:
“
Dry” is not available for the concealed duct
high static type.
3
Push the button to stop running.
The operation lamp turns off.
4 Basic operation
Turn on the power switch
• When turned on, the separation line appears and blinks on the remote controller display.
* The remote controller will not work for about 1 minute after turning on the power. This is not a
malfunction.
• When you use the air conditioner for the fi rst time or change the settings, follow the procedures below.
From next time, pushing the
button starts running of the air conditioner with the chosen settings.
■
Preparation
■
Operations
■
Changing the fan speed
REQUIREMENT
• Keep the power switch turned on during use.
• When you resume using the air conditioner after a long period of disuse, turn on the power switch at least 12
hours before starting running.
Heat-pump model
(Dehumidify)
Heat
Dry
Dry Cool
Cool
Fan
Fan
(Dehumidify)
Cooling only model
1
Push the “FAN ” button to select a fan
speed.
• Each time you push the button, fan speed and
its indication change in the following order:
(“
Auto” cannot be selected in the FAN
mode.)
• When heating, if the room does not heat
up using “
Low”, select “ High” or “
Medium”.
• The temperature sensor detects the return
air temperature at the indoor unit, which may
slightly differ from the actual room temperature
depending on installation condition. Set
temperature is a target of room temperature.
• The fan speed selection function is not
available for the concealed duct high static
type. Fan speed is fi xed and the indicator is
fi xed to “
High”
Low Medium High
Auto
– 11 –
21-EN 22-EN
To Next Page
Loading...
