Toshiba MV13N3C - Antenna Connections

11
ENGLISH
Combination VHF/UHF Antenna (Separate VHF and UHF 300 ohm twin-lead wires)
Combination VHF/UHF Antenna (Single 75 ohm cable or 300 ohm twin-lead wire)
Connect the 75 ohm cable from the combination VHF/
UHF antenna to the Antenna Jack.
If your combination VHF/UHF antenna has a 300 ohm
twin-lead wire, the use of the 300-75 ohm Matching
Transformer may be necessary.
Connect the UHF 300 ohm twin-lead wire to the
Combiner (not supplied). Connect the VHF 300 ohm
twin-lead wire to the 300-75 ohm Matching Trans-
former. Attach the Transformer to the Combiner, then
attach the Combiner to the Antenna Jack.
Connect the VHF 75 ohm cable and UHF 300 ohm
twin-lead wire to the Combiner (not supplied). Attach
the Combiner to the Antenna Jack.
Separate VHF/UHF Antennas (75 ohm VHF cable and 300 ohm UHF twin-lead wires)
If you are using an indoor or outdoor antenna, follow the instructions below that correspond to your antenna
system. If you are using a cable TV service (CATV), see page 13 for Cable TV connections.
ANTENNA CONNECTIONS
ANT.
ANT.
75 ohm
Coaxial
Cable
300-75 ohm
Matching
Transformer
Antenna
Jack
Antenna
Jack
ANT.
300-75 ohm
Matching
Transformer
UHF 300 ohm
VHF 300 ohm
Antenna
Jack
Combiner
ANT.
UHF 300 ohm
VHF 75 ohm
Antenna
Jack
Combiner
5E20501A E P10-19 13/11/2002, 19:1111