setting (continued)
You must set the date and time manually for Timer Recordings,
ON/OFF Timer and Daylight Saving Time if the Auto Clock
process did not set them correctly.
[
Manual clock setting ........... 1
EXAMPLE: Setting the clock to "8:30 AM", 29th. (FRI)
March, 2002.
Press MENU.
MENU
SETUP
Press t or _ to select the "SYSTEM SET-UP",
then press ENTER.
f MENU:
:_: [ I TiMERRECS_ l
I I TVSE"r:uP /
mR I I CHSET-UP I
I _I/AUTORE_EAT ON,OFF I
I - I SYSTEMSET-UP /
(M_EN_ER/MENU)
k,, :
Press | or _ to select "CLOCK SET", then
press ENTER.
....... /.I CLOCK
l _NGUAG_GUE
[ IAUTOGL_K _ OFF
[ I STANDARD TI_
| I DAYEP3HT_V_NG l_ME
[
........ [ <_,,_=_=
Press | or _ to set the month, then press
ENTER.
( CLocK_ /
. : I DAY 1_(Ffl) /
........................ / YEAR _ l
/ TIME 12:®_ /
5
Set the day, year and time as in step 4.
r C_OCKS_ 1
/ DAY
I °.°.1
! !
<M_EPJCANCEUMI_.U)
After setting the clock, date and time starts
functioning automatically.
ITo make corrections any time during the process
Press CANCEL repeatedly until the item you want to
change blinks, then press | or |.
Notes:
• After a power failure or disconnection of the power, the timer
settings will be lost. In this case, reset the present time.
• When you set the minute, you can change in lO-minutes step
by holding down t or _.
122
To Next Page
Loading...
