Toshiba MW24FP1 - Memorize Channels; Automatic Memory Tuning; Add;Delete Channels

DISASSEMBLY INSTRUCTIONS
B3-1
3. REMOVAL OF DVD DECK PARTS
NOTE
1. Do not disassemble the DVD DECK PARTS except listed
parts here. Minute adjustments are needed if the disas-
semble is done. If the repair is needed except listed parts,
replace the DVD MECHA ASS’Y.
3-1: TRAY (Refer to Fig. 3-1-A)
1.
2.
Set the Tray opened. (Refer to the DISC REMOVAL
METHOD AT NO POWER SUPPLY)
Unlock the support 1 and remove the Tray.
Main Frame Ass’y
1
Tray
Fig. 3-1-A
NOTE
1. In case of the Tray installation, install them as the circled
section of Fig. 3-1-B so that the each markers are met.
Fig. 3-1-B
Tray
Main Frame Ass’y
3-2: MAIN CHASSIS ASS’Y (Refer to Fig. 3-2-A)
1.
2.
3.
Remove the Main Chassis Ass’y from the Insulator (R).
Unlock the support 1.
Remove the Main Chassis Ass’y.
Fig. 3-2-A
Insulator (R)
(Green)
1
Main Frame Ass’y
Main Chassis Ass’y
3-4: CLAMPER ASS’Y/INSULATOR(R)/LEVER SWITCH
(Refer to Fig. 3-4-A)
1.
2.
3.
4.
5.
Remove the screw 1.
Remove the Lever Switch.
Remove the 2 Insulator (R).
Press the Clamper and rotate the Clamper Plate clockwise,
then unlock the 3 supports 2.
Remove the Clamper Plate, Clamper Magnet and Clamper.
Insulator (R)
(Green)
Insulator (R)
(Green)
Clamper Plate
Clamper Magnet
Main Frame
Lever Switch
Clamper
1
2
2
2
Fig. 3-4-A
Fig. 3-2-B
Main Chassis Ass’y
Rack Loading
Move it to the direction
of the arrow.
Main Frame Ass’y
1
Check Lock
2
3
4
5
6
6
5
4
NOTE
1. In case of the Main Chassis Ass’y, install it from (1) to (6)
in order. (Refer to Fig. 3-2-B)
Rack Loading Spring
Rack Loading
Main Gear
1
Main Frame Ass’y
Rack L Spring
3-3: RACK LOADING/MAIN GEAR/ RACK LOADING
SPRING/ RACK L SPRING (Refer to Fig. 3-3)
1.
2.
3.
Remove the Rack L Spring.
Press down the catcher 1 and slide the Rack Loading.
Remove the Rack Loading, Rack Loading Spring and
Main Gear.
Fig. 3-3