23
Basic setup
Manual clock setting
You must set the date and time manually for timer recordings, ON/OFF timer and daylight saving time if the auto clock
process did not set them correctly.
Notes:
•
After a power failure or disconnection of the power, the timer
settings will be lost. In this case, reset the present time.
• When you set the minute, you can change in 10-minutes step
by holding down or .
Press MENU in the TV/VCR mode, then press
or to select TV SETUP menu.
EXAMPLE: Setting the clock to “8:30 AM”, 29th. (SAT)
October, 2005.
1
After setting the clock, date and time starts
functioning automatically.
5
Press or to select “CLOCK SET”, then
press
. The CLOCK SET menu will appear.
2
Press or to set the month, then press .
3
Set the day, year and time as in step 3, then
press ENTER.
4
To make corrections any time during the process
Press or repeatedly until the item you want to
change blinks, then set the item again.
/ / /
MENU
ENTER
TV SETUP
LANGUAGE ENGLISH
CLOCK SET
AUTO CLOCK ON
STANDARD TIME
DAYLIGHT
SAVING TIME AUTO
: SELECT : ADJUST
RETURN : END
TV SETUP
LANGUAGE ENGLISH
CLOCK SET
AUTO CLOCK ON
STANDARD TIME
DAYLIGHT
SAVING TIME AUTO
: SELECT : ADJUST
RETURN : END
RETURN
5U30101B [E]p20-23 4/1/05, 3:24 PM23
To Next Page
Loading...
