152 Q9 ASD Installation and Operation Manual
kWH Memory Selection
Program Special Controls
This parameter sets the unit of measure for the power/time display.
Settings:
1 kW
10 kW
100 kW
1000 kW
10000 kW
Direct Access Number — F749
Parameter Type — Selection List
Factory Default — 1 kW
Changeable During Run — No
EASY Parameters
No Path — Direct Access Only
Parameters F750 – F782 are under development and are unavailable at the time of
this release.
Direct Access Number — F750 – F782
Parameter Type — N/A
Factory Default — N/A
Changeable During Run — N/A
LCD Contrast
Program Special Controls
This parameter sets the contrast of the LCD screen.
Settings:
0 – 7
Direct Access Number — F790
Parameter Type — Selection List
Factory Default — 4
Changeable During Run — No
Baud Rate (RS485 2-Wire)
Program Communication Settings
This parameter plays a role in the setup of the communications network by
establishing the Baud Rate of the communications link.
The communications network includes other ASDs and Host/Control computers
that monitor the status of the ASD(s), transfers commands, and loads or modifies
the parameter settings of the ASD.
Changes made to this parameter require that the power be cycled (off then on) for
the changes to take effect.
Settings:
0 — 9600
1 — 19200
2 — 38400
Direct Access Number — F800
Parameter Type — Selection List
Factory Default — 19200
Changeable During Run — Yes
Units — bps
F749 F800
To Next Page
Loading...
