178 Q9 ASD Installation and Operation Manual
Input Function Command 1
Program My Function Unit 7
This parameter is used to assign a user-selected logical operator to two user-
selected Input Function Target variables, enable a counter/timer function, or
perform a hold/reset function.
Table 9 on pg. 194 lists the available selections. Their use and selection
requirements are described in an example at F977.
Direct Access Number — F954
Parameter Type — Selection List
Factory Default — 0 (NOP)
Input Function Target 2
Program My Function Unit 7
This parameter plays a role in the setup of the My Function feature by selecting
the functionality of the programmable Input Function Target 2 terminal.
This setting assigns the function of the programmable Input Function Target 2
terminal to any of the user-selectable functions listed in Table 5 on pg. 188, Table
7 on pg. 190, or Table 8 on pg. 192.
See F977 for more information on this parameter.
Direct Access Number — F955
Parameter Type — Selection List
Factory Default — 0 (Disabled)
Changeable During Run — Yes
Input Function Command 2
Program My Function Unit 7
This parameter is used to assign a user-selected logical operator to two user-
selected Input Function Target variables, enable a counter/timer function, or
perform a hold/reset function.
Table 9 on pg. 194 lists the available selections. Their use and selection
requirements are described in an example at F977.
Direct Access Number — F956
Parameter Type — Selection List
Factory Default — 0 (NOP)
Input Function Target 3
Program My Function Unit 7
This parameter plays a role in the setup of the My Function feature by selecting
the functionality of the programmable Input Function Target 3 terminal.
This setting assigns the function of the programmable Input Function Target 3
terminal to any of the user-selectable functions listed in Table 5 on pg. 188, Table
7 on pg. 190, or Table 8 on pg. 192.
See F977 for more information on this parameter.
Direct Access Number — F957
Parameter Type — Selection List
Factory Default — 0 (Disabled)
Changeable During Run — Yes
Output Function Assigned
Program My Function Unit 7
This parameter plays a role in the setup of the My Function feature by selecting
the functionality of the Output Function Assigned terminal.
This setting assigns the function of the programmable Output Function Assigned
data location to 1 of the functions listed in the Input Setting field of Table 7 on
pg. 190.
Settings:
0 – 3099
See the My Function Instruction Manual (P/N E6581335) and F977 for more
information on this parameter.
Direct Access Number — F958
Parameter Type — Selection List
Factory Default — 0 (Disabled)
Changeable During Run — Yes
F954 F958
To Next Page
Loading...
