Q9 ASD Installation and Operation Manual 181
Monitor Output Function 21
Program My Function Monitor
This parameter plays a role in the setup of the My Function feature by
establishing the function that is to be recorded and output as the Peak, Minimum,
or Average value as selected at parameter F968.
Select the Monitor Display Input Setting number from Table 8 on pg. 192 to
output the corresponding function.
Use the Communication Number if operating using communications.
See the My Function Instruction Manual (P/N E6581335) for a complete
description of the setup requirements and operational information of the Monitor
Output Function parameter.
Direct Access Number — F967
Parameter Type — Selection List
Factory Default — 2000
Changeable During Run — Yes
Monitor Output Function Command 21
Program My Function Monitor
This parameter plays a role in the setup of the My Function feature by allowing
the user to select the Peak, Minimum, or Normal (Avg.) value of the parameter
F967 selection to be recorded and output as a monitored function.
Settings:
0 — Normal
1 — Peak
2 — Minimum
See the My Function Instruction Manual (P/N E6581335) for a complete
description of the setup requirements and operational information of the Monitor
Output Function parameter.
Direct Access Number — F968
Parameter Type — Selection List
Factory Default — Normal
Changeable During Run — Yes
Monitor Output Function 31
Program My Function Monitor
This parameter plays a role in the setup of the My Function feature by
establishing the function that is to be recorded and output as the Peak, Minimum,
or Average value as selected at parameter F970.
Select the Monitor Display Input Setting number from Table 8 on pg. 192 to
output the corresponding function.
Use the Communication Number if operating using communications.
See the My Function Instruction Manual (P/N E6581335) for a complete
description of the setup requirements and operational information of the Monitor
Output Function parameter.
Direct Access Number — F969
Parameter Type — Selection List
Factory Default — 2000
Changeable During Run — Yes
F967 F969
To Next Page
Loading...
