Toshiba Q9 - Page 192

182 Q9 ASD Installation and Operation Manual
Monitor Output Function Command 31
Program  My Function Monitor
This parameter plays a role in the setup of the My Function feature by allowing
the user to select the Peak, Minimum, or Normal (Avg.) value of the parameter
F969 selection to be recorded and output as a monitored function.
See the My Function Instruction Manual (P/N E6581335) for a complete
description of the setup requirements and operational information of the Monitor
Output Function parameter.
Settings:
0 — Normal
1 — Peak
2 — Minimum
Direct Access Number — F970
Parameter Type — Selection List
Factory Default — Normal
Changeable During Run — Yes
Monitor Output Function 41
Program  My Function Monitor
This parameter plays a role in the setup of the My Function feature by allowing
the user to select the Peak, Minimum, or Normal (Avg.) value of the parameter
F972 selection to be recorded and output as a monitored function.
Settings:
0 — Normal
1 — Peak
2 — Minimum
See the My Function Instruction Manual (P/N E6581335) for a complete
description of the setup requirements and operational information of the Monitor
Output Function parameter.
Direct Access Number — F971
Parameter Type — Selection List
Factory Default — Normal
Changeable During Run — Yes
Monitor Output Function Command 41
Program  My Function Monitor
This parameter plays a role in the setup of the My Function feature by
establishing the function that is to be recorded and output as the Peak, Minimum,
or Average value as selected at parameter F971.
Select the Monitor Display Input Setting number from Table 8 on pg. 192 to
output the corresponding function.
Use the Communication Number if operating using communications.
See the My Function Instruction Manual (P/N E6581335) for a complete
description of the setup requirements and operational information of the Monitor
Output Function parameter.
Direct Access Number — F972
Parameter Type — Selection List
Factory Default — 2000
Changeable During Run — Yes
F970 F972