Toshiba RAS-24J2AVSG-E - Page 118

Remarks
Electric part cover
Screw
Connectors
Drain pan
Drain pan
assembly
8
Unit display
Screw
- 118 -
<To re-installation>
- Press the drain pan into the back body.
- Please make sure ribs of drain pan in left
and right side must be install to lock position.
- Press the two center arms of drain pan to back
body.
Back body
Drain pan
Rib of drain pan
Back body
Drain pan
Rib of drain pan
Drain pan
Center arms
of drain pan
Back body
6) Remove fixing screw of the unit display
and remove unit display.
7) Remove drain pan can be selected remove
drain hose or not remove drain hose following:
- Not remove drain hose;
Pulling out the drain pan from back body,
then holding the drain pan with main unit.
- Remove drain hose;
Drain hose can be removed follow the
procedure item 7 . After that remove the
drain pan from main unit.
1) Follow the procedure item .
3
2) Remove screw holding the electric part
cover.
3) Disconnect the louver motor connector (5P)
from P.C. board assembly.
4) Disconnect the cord motor of Louver VT (5P)
from the Louver VT (L/R) connector.
5) Disconnect the cord motor of Louver motor
(L) (5P) from the Louver motor (L) connector.
3
L 2
1
N
Louver motor connector
(black)
Louver motor VT (L)
connector (white)
Louver motor VT (R)
connector (black)
Louver motor (L)
connector (blue)
(blue)
Louver motor
connector
P.C.board