Toshiba RAS-M24SKV-E - Specific Remote Operation Modes Continued; Timer Operation Settings

– 37 –
4. DRY OPERATION (COOLING ONLY)
For dehumidification, a moderate cooling performance is controlled automatically.
1. Push MODE : Select Dry .
2. Push
TEMP
MODE : Set the desired temperature.
5. Hi POWER OPERATION
To automatically control room temperature and airflow for faster cooling or heating operation
(except in DRY mode)
Push Hi-POWER : Start and stop the operation.
6. ECO OPERATION
To automatically control room to save energy (except in DRY mode)
Push ECO : Start and stop the operation.
Note:
Cooling operation; the set temperature will increase automatically 1 degree/hour for 2 hours
(maximum 2 degrees increase). For heating operation the set temperature will decrease.
7. TEMPORARY OPERATION
In case of the misplaced or discharged remote controller
• Pushing the RESET button, the unit can start or stop
without using the remote controller.
• Operation mode is set on AUTOMATIC operation, preset
temperature is 24°C and fan operation is automatic speed.
8. TIMER OPERATION
Everyday timer allows the user to set both the ON and OFF timers and will be activated on a daily basis.
Setting Everyday Timer
• During the every day timer is activation, both arrows ( or ) are indicated.
1
2
3
Setting the ON Timer
Push
ON
: Set the desired ON timer.
Push
SET
: Set the timer.
Push
CLR
: Cancel the timer.
Setting the OFF Timer
Push
OFF
: Set the desired OFF timer.
Push
SET
: Set the timer.
Push
CLR
.
1
2
Push
ON
: Set the ON timer.
Push
OFF
: Set the OFF timer.
3
4
Push
SET
.
Push
SET
button during the
(
or
) mark flashing.