1-9-3 E3NG0INT
HOW TO INITIALIZE THE HDD & DVD/VCR
To put the program back at the factory-default, initialize the DVD recorder & VCR as the following procedure.
< HDD/DVD Section >
1. Turn on the HDD & DVD/VCR.
2. To put the HDD & DVD/VCR into the HDD mode, press [HDD] on the remote control unit.
3. To put the HDD & DVD/VCR into the Version display mode, press [VARIABLE SKIP], [1], [2], and [3] buttons
on the remote control unit in that order within three seconds.
Fig. a appears on the screen.
4. Press [ENTER] button, then the HDD & DVD/VCR starts initializing. When the initializing is completed, the
HDD & DVD/VCR exits the Version display mode and turns off the power automatically.
* To move into the Normal mode from the Version display mode, press [RETURN] button on the remote
control unit instead of [ENTER] button.
* When [ ] button is pressed before [ENTER] button is pressed, the HDD & DVD/VCR exits the Version
display mode, then the power turns off.
NOTE: When initializing, “Current Clock”, “Setup Changing Item”, “Channel Setup”, “Area Setup” and “Program”
are initialized.
MODEL NAME :
DVB-T VERSION :
FE VERSION :
BE VERSION :
TT VERSION :
DV UNIQUE ID :
LD ADJUSTMENT :
DISC ADJUSTMENT :
DEFAULT SETTING : ENTER
EXIT : RETURN
OK
OK
*1: "
*******
" differs depending on the models.
*2: Firmware Version differs depending on the
models, and this indication is one example.
Fig. a Version Display Mode Screen
F/W VERSION DISP
*******
*.**
***_***_***
************
*********
******** ********
To Next Page
Loading...
Need help?
General
