43
PROBLEM SOLVING
English
a
Set the Colour to
Auto.
and exit.
b
Go to the
Picture settings
menu and adjust the tint.
Q
Why are the LEDs on the front of the television
flashing?
A
Check the table below.
LED indication
Condition Solution
LED-2 LED-1
OFF Green (Solid) The TV is operatin
properly.
–
OFF Red (Solid) Standby with Power-
On
–
Green
(Solid)
Red (Solid) Active standby
(Digital mode)
–
OFF Green (Solid) Sleep timer
(Analogue mode)
–
OFF RED Blinks
0.5 sec cycle
Power protect
detection.
Turn OFF the TV and
unplug the power
cord. Plug the power
cord in again and turn
ON the TV.
OFF Red Blinks
1 sec cycle
Abnormal operation
of BUS line.
OFF 2 times
flashing with
2 sec interval
Abnormal operation
(Initialization error).
Q
Why does the GREEN Active Standby LED
sometimes take longer to go out?
A
When put into standby the television’s active standby
will automatically search all available channels for
downloads, provided
Auto upgrade
is
On
. The time
it takes to do this may vary.
Q
Why are the colours wrong when an NTSC source is
played?
A
Connect the source via a SCART lead and play.
Select
Manual setting
from the
SET UP
menu.
LED-2 LED-1
EXT2 A V C R
OK
MENU EXIT
Manual setting
Colour system: Auto.
Store
Back Watch TV
Q
Why don't the devices connected via HDMI operate
properly?
A
Make sure to use cables with the HDMI logo
(see page 9).
Some early HDMI equipment may not work properly
with the latest HDMI TV products, due to new standard
adoption. Try
Lip Sync
setting to
Off
.
Q
Why don't the REGZA-LINK devices work?
A
When the connected REGZA-LINK device does not
work correctly after you have changed settings of the
device, turn off your television and unplug the power
cord, then plug and turn on again.
Unplug the HDMI cable of the REGZA-LINK device and
lead again.
Q
Why is the REGZA-LINK logo still showing when
the equipment has been disconnected?
A
If the REGZA-LINK is disconnected the logo will
disappear after approximately one minute.
00GB_XV555D_Euro_kai.book Page 43 Tuesday, September 2, 2008 7:01 PM
To Next Page
Loading...
