Toshiba S2E21 - Page 56

TOSHIBA
6F9EOlll
Item
Test method
Decision
Test
circuit
(single
phase)
Opet-at- 1) On P2, check that
Figure 15
ing 8 R is 0. When
(-$$' x TX (set) +10X
time
not 0. clear OR.
1. R 1st: Starting current
2) Quickly increase the TSC: Allowable starting-time
applied current from
0 to 3 times the
rated current (I N )
and measure the time
it takes for the
relay to trip.
Operat- 1) On P2. check that
Tst
Figure 15
ing B R is 0. When ' - TX
- *10x
point not zero, either
!EP
wait or clear 8 R
Tst: Starting time
on P35.
2) Apply the starting
current (1st) and
measure the % value
of 6'R on P2 when
the lock output is
produced.
--
--
- 103 -
www . ElectricalPartManuals . com