Toshiba Satellite A500 - AC-IN Cable, RJ11(or FM) Cable and USB Cable

4 Replacement Procedures 4.14 AC-IN cable, RJ11(or FM) cable and USB cable
4.14 DC-IN cable, RJ11(or FM) cable and USB cable
DC-IN cable, RJ11(or FM) cable and USB cable
Remove the DC-IN cable, RJ11(or FM) cable and USB cable according to the following
procedures and Figure 4-19.
1. Disconnect the DC-IN cable from CN6000 on the system board.
2. Remove the DC-IN cable.
3. Remove the RJ11(or FM) cable.
4. Disconnect the two connectors USB cable from CN18 on the system board.
5. Remove one M2.5x10 black flat head screw securing the two connectors USB cable.
6. Remove the two connectors USB cable.
7. Disconnect the one connector USB cable from CN814 on the system board.
8. Remove two M2.5x4 black flat head screws securing the one connector USB cable.
9. Remove the one connector USB cable.
CN18
CN814
CN6000
USB cable
FM cable
MDC cable
DC IN cable
USB cable
M2 5x10 black flat haed screw.
M2 5x4 black
flat head screw
.
Figure 4-19 Removing the AC-IN cable, RJ11(or FM) cable and USB
cable
4-38 Satellite/Satellite Pro/A500/A505/A507/dynabook Maintenance Manual