4 Replacement Procedures 4.26 Power Board, Switch Board and Logo LED Board
4-74 Satellite/Satellite Pro/A500/A505/A507/dynabook Maintenance
Manual
Installing the Power Board, Switch Board and Logo LED Board
Install the Power Board, Switch Board and Logo LED Board according to the following
procedures and Figure 4-44.
1. Seat the power board in the correct position and secure it with the two M2x3.5 black
flat head screws.
2. Seat the switch board in the correct position and secure it with the two M2x3.5 black
flat head screws.
3. Connect the switch cable to CN9300 on the button board.
4. Seat the Logo LED board in the correct position and secure it with the one M2x3
black flat head screw.
5. Connect the Logo LED board cable to CN9302 on the button board.
To Next Page
Loading...
