Toshiba Satellite A50S Series - Page 242

4 Replacement Procedures 4.6 Wireless LAN card
3. Disconnect two wireless LAN cables from connectors on the wireless LAN card.
4. Peel off one glass tape and two insulators remove the cables from the guide.
5. Open the left and right latches holding the wireless LAN card and remove the
wireless LAN card.
4-20 [CONFIDENTIAL] Satellite A50S/TECRA A3X Maintenance Manual (960-534)
Wireless LAN card
Wireless LAN Antenna Cable
Glass Tape
Guide
Insulator
Insulator
Figure 4-10 Removing Wireless LAN card
Installing the Wireless LAN card
The following describes the procedure for installing a wireless LAN card (See Figure 4-9, 4-
10).
1. Insert the wireless LAN card terminals at 45-degree slant into the connector on the
computer and press the wireless LAN card from the top to secure.
2. Pass the black and white wireless LAN cables along the guide and secure them with
one glass tape and two insulators.
3. Connect the wireless LAN cables to the connectors on the wireless LAN card.
(White cable = MAIN, Black cable = AUX)
4. Attach the mini PCI slot cover and secure it with the following screw.
• M2x4B BIND or LH STICK x1