Toshiba Satellite A50S Series - 4.20 LCD Unit and FL Inverter

4.20 LCD Unit/FL Inverter 4 Replacement Procedures
4.20 LCD Unit/FL Inverter
Removing the LCD unit/FL inverter
The following describes the procedure for removing the LCD unit and FL inverter (See
Figure 4-40 to 4-42).
1. Peel off two mask seals from the front of the display mask and remove the following
screws.
• M2.5x6B THIN BIND screw x2
2. Insert your fingers between the display mask and the LCD and remove the display
mask after unlatching the display mask.
Mask Seal
M2.5×6B THIN BIND
Display Mask
Figure 4-40 Removing Display Mask
Satellite A50S/TECRA A3X Maintenance Manual (960-534) [CONFIDENTIAL] 4-57