4.23 Fluorescent Lamp Replacement Procedures
4. Remove the board assembly, adhesive tape, light guide and cover assembly bottom.
1) Remove the board assembly.
2) Remove the adhesive tape securing the sheets (four points).
3) Remove the sheets and light guide.
NOTE: No penetration of foreign object is indispensable not to scratch the sheets.
4) Remove the screw and cover assembly bottom.
NOTE: Maximum value of torque is 1.5kg
•
cm.
Board assembly
dhesive tape
dhesive tape
Sheets
&
Light guide
Screw Screw
Cover assembly bottom
Figure 4-88 Replacing 15.0 Inch LG.Philips fluorescent lamp (XGA) (4)
Satellite A50S/TECRA A3X Maintenance Manual (960-534) [CONFIDENTIAL] 4-101
To Next Page
Loading...
