4.23 Fluorescent Lamp Replacement Procedures
4. Stick the out side tape and cover shield.
1) Install the tape shield and adhesive tape to fix the top case. Be careful not to
apply excessive force to the top case.
2) Install the cover shield (C). Be careful not to apply excessive force to the
control PCB.
CAUTION: Wear anti-static gloves to prevent circuit damage caused by ESC.
3) Install the cover shield (G). Be careful not to apply excessive force to the gate
TCP.
4) Stick the adhesive tape to fix the B/L wire. Be careful not to apply excessive
force to the B/L wire.
Cover shield (C)
Cover shield (G)
Adhesive tape
Adhesive tape
Tape shield
Figure 4-100 Replacing 15.0 Inch LG.Philips fluorescent lamp (SXGA+) (8)
Satellite A50S/TECRA A3X Maintenance Manual (960-534) [CONFIDENTIAL] 4-113
To Next Page
Loading...
