3.7 Storage 3 Diagnostic Programs
invalid. If user chooses Special Size, the test of IDE HDD will be taken
according to the coverage range that user chooses or time.
e Block
Address).
the coverage rate in percentage of the total disk.
l
ined range of the
total disk to be tested.
ode—Choose test mode from the following options:
e disk, then read it out and compare the two
value;
(2) Read Verify —Read data only;
(3) Unprotected Write—Write data on the disk without backup original data.
Option—Select sequential test or random test
2. Sequential/Random Seek
The test item is to check the correctness of the HDD’s sector’s seeking function.
This test item involves the following parameters:
LBA Start, LBA End--Specify the start and end byte in LBA (Larg
Percent—Specify
Time Limit(h): Choose or Input the time (hour) of the defined range of the tota
disk to be tested.
Time Limit(m): Choose or Input the time (minute) of the def
Test M
(1) Read & Write –Write data on th
Satellite/Satellite Pro/C650D/C655D Maintenance Manual
41
To Next Page
Loading...
