4 Replacement Procedures 4.10 System board
4.10 System Board
Removing the System Board
NOTE: Be careful of the eject button for the PC card. It can be damaged when removing
the board. Make sure it is securely installed.
Remove the System Board according to the following procedures and Figure 4-13.
1. Release one M2.5x6 black flat head screw securing the system board.
2. Disconnect DC-IN cable from CN6000 and remove the DC-IN cable from bottom
cover.
3. Remove one M2x3 black flat head screw securing the FAN.
4. Remove the system board.
DC IN cable
CN6000
System board
M2 5x6 black flat head screw.
M2x3 black flat head screw
Figure 4-13 Removing the system board
4--28 Satellite/Satellite Pro/C650D/C655D Maintenance Manual
To Next Page
Loading...
