4.16 LED Module (LED panel) 4 Replacement Procedures
Installing the LED Module
NOTE: LCD/FL cable must be carefully peeled away before disconnecting it from the
module.
Install the LED module according to the following procedures and Figures 4-27, 4-28.
1. Turn the LED upside down.
2. Connect the LED cable to the LED module connector.
3. Turn the LED right side up.
4. Place the LED bracket in the correct position and secure it with two M2.5x5 black
flat head screws on each side.
5. Please the LED module in the correct position and secure it with one M2.5x5 black
flat heat screws on each side.
6. Stick the rubber sheet to hold the cable on base enclosure.
7. Connect CCD cable to CCD module
CAUTION: When installing the LED module, please follow below instruction:
When plug in LED cable into LED module connector, need to plug horizontally. For Sharp
panel, if LED cable connector is not plugged horizontally, it may be damaged.
Satellite/Satellite Pro/C650D/C655D Maintenance Manual 4-45
To Next Page
Loading...
