4 Replacement Procedures 4.9 Display Assembly
4.9 Display Assembly
Removing the Display Assembly
CAUTION: Use care to avoid that the antenna cable is not caught between the display
assembly and computer.
Remove the display assembly according to the following procedures and Figures 4-12.
1. Turn the computer upside down and remove two M2.5x6 black flat head screws.
2. Restore the normal computer placement and open the display panel.
LCD FL cable
Wireless LAN antenna
CN3000
M2 5x6 black flat head screw.
Figure 4-12 Removing the display assembly
3. Disconnect the LCD/FL cable from CN3000 on the system board.
4. Remove four M2.5x6 black flat head screws securing the LCD module to the bottom
cover.
5. Remove the wireless antenna cables from the bottom cover.
4-26 Satellite/Satellite Pro/C650D/C655D Maintenance Manual
To Next Page
Loading...
