Replacement Procedures
Satellite M300 and Satellite Pro M300 Maintenance Manual (960-Q08)
4-19
4.6 Memory module
CAUTION: The power of the computer must be turned off when you remove a memory
module.
Do not touch memory module terminals. Any dirt on the terminals may cause
memory access problems.
Never press hard or bend a memory module.
Remove a memory module
To remove a memory module, confirm that the computer is not in boot mode. Then perform
the following procedure (See Figure4-6 and 4-7).
1. Loose the screws which secure the memory slot cover.
• 2.5 x 4.0B BIND screw x3
2. Remove the memory slot cover.
3. Open the left and right latches and remove the memory module.
To Next Page
Loading...
